The SBR-RIO is a companion board to the CompactPCI® Serial peripheral card SBX-DUB, a 16-port xHCI SuperSpeed host controller. All USB 3.0 channels are passed across the the SBX-DUB backplane connectors P3/P4 to the corresponding SBR-RIO receptacles rJ3/rJ4.
The CompactPCI® Serial rear I/O module SBR-RIO is equipped with 16 USB 3.0 receptacles in total. 8 ports are available from the back panel, for attachment of external devices. Another 8 connectors are provided on-board, for system internal usage.
The P2/rJ2 backplane connectors commit +12V system power to a DC-DC converter on the SBR-RIO, which delivers +5V VBUS to the USB connectors. 1.5A power switches, individually assigned to each USB receptacle, prevent from potential damage caused by overcurrent or even a short circuit represented by the external load.
EKF offers design support for custom specific variants of the SBR-RIO, e.g. 16 x on-board connectors, or 16 x USB 3.0 rear panel receptacles (8 HP assembly).
Features
- PICMG® CompactPCI® Serial standard (CPCI-S.0) rear board (rear I/O module)
- 3U/4HP form factor 100x80mm2
- CPCI-S backplane connectors rJ2, rJ3, rJ4, proprietary pin assignment matches with SBX-DUB controller card
- rJ4: 8 x USB 3.0 ports 1.1 - 2.4
- rJ3: 8 x USB 3.0 ports 3.1 - 4.4
- rJ2: +12V power
USB Interfaces
- 8 x on-board USB 3.0 connectors
- 8 x rear panel USB 3.0 connectors
- Complies with USB 3.0 xHCI (eXtensible host controller interface) SuperSpeed
- Complies with USB 2.0 high-speed, full-speed, low-speed
- ESD protection (TVS diodes)
- EMC protection (common mode inductors)
- VBUS (+5V) 1.5A high current power switches assigned to all connectors
- Rear panel provided with 16 x power good LEDs
- Custom specific rear I/O module design offered
Ordering Options
Manuf. Part No | | Part Description |
SBR-0100-RIO | | Rear I/O module, suitable for SBX-DUB, 8 x back panel USB 3.0 connectors, 8 x on-board USB 3.0 connectors, powered via rJ2 (backplane) |
|