Conduction Cooled PMC, Isolated 2 x CAN Bus
|
The TPMC310 is a conduction cooled single-width 32 bit PMC module providing two channel of high speed CAN bus interface.
The PLX PCI9030 PCI Target Chip is used for the PCI interface.
Two Philips SJA1000 CAN controllers (CAN specification 2.0B supported) are used for the two CAN bus channels.
The CAN bus I/O interface provides two independent channels, isolated from system logic and from each other.
CAN High Speed transceivers are used for the CAN bus I/O interface. An on board termination option (solder pads) is provided for each CAN bus channel allowing to configure on board termination and pass through mode for the CAN bus.
The TPMC310 uses the P14 I/O connector for the CAN bus I/O interface.
Software support (TDRV010-SW-xx) for different operating systems is available.
Features
- Conduction Cooled single-width 32 bit PMC module conforming to IEEE P1386.1
- PCI 2.1 compliant interface
- Board size: 144 mm x 74 mm
- CAN Bus Interface
- Two channel High Speed CAN interface
- Two Philips SJA1000 CAN controller
- Supports CAN specification 2.0B
- I/O interface based on TJA1050 transceiver, channels isolated from system logic and from each other
- On board termination option for each CAN bus channel
- Operating temperature range –40°C...+85°C
Ordering Options
| Manuf. Part No. | | Product Description |
| TPMC310-10R | | ccPMC, 2 x isolated CAN Bus based on Philips SJA1000, ISO11898 Can Hig Speed, P14 I/O: Two independent CAN Bus Controller based on Philips SJA1000 supporting both, Conduction Cooled PMC; standard and extended frames according to CAN specification 2.0 part A and B; Physical interface optically isolated CAN-HIGH-SPEED (ISO11898); Channels Isolated against each other; P14 I/O; PCI I/O signaling voltage 3.3V and 5V; Operating temperature -40°C...+85°C |
Software and Documentation
| Manuf. Part No. | | Product Description |
| TPMC310-DOC | | User Manual for TPMC310 |
| TDRV010-SW-25 | | Integrity Software Support: Device driver; Source code; Programmer documentation |
| TDRV010-SW-42 | | VxWorks Software Support: Legacy and VxBus-enabled Software Support; VxWorks Device driver; Source code; Programmer documentation |
| TDRV010-SW-65 | | Windows Software Support: Device driver; Programmer documentation |
| TDRV010-SW-82 | | Linux Software Support: Device driver; Source code; Programmer documentation |
| TDRV010-SW-95 | | QNX Software Support: Device driver; Source code; Programmer documentation |
For other operating systems please contact systerra.
Accessories
| Manuf. Part No. | | Product Description |
| TPIM001 | | PIM I/O Module with 50 pin Connector: PIM I/O module used with any PIM carrier; I/O lines 1 to 50 routed to a HD50 SCSI-2 type connector in EMI front panel; Operating temperature -40°C...+85°C |
|
|
