The TCP466 is a standard 3U 32 bit CompactPCI module and offers 4 channels of high performance RS232/RS422/RS485 programmable asynchronous serial interface. The module offers front panel I/O with a HD50 SCSI-2 type connector. The TCP466-20R module offers additional J2 rear I/O.
The serial channels can be individually programmed to operate as RS232, RS422 or RS485 full duplex/half duplex interface. In addition programmable termination is provided for the RS422/RS485 interfaces. After power-up all serial I/O lines are in a high impedance state.
Each RS232 channel supports RxD, TxD, RTS, CTS and GND. RS422 and RS485 full duplex support a four wire interface (RX+, RX-, TX+, TX-) plus ground (GND). RS485 half duplex supports a two wire interface (DX+, DX-) plus ground (GND).
Each channel has 64 byte transmit and receive FIFOs to significantly reduce the overhead required to provide data to and get data from the transmitters and receivers. The FIFO trigger levels are programmable and the baud rate is individually programmable up to 921.6 kbps for RS232 channels and 5.5296 Mbps for RS422/RS485 channels. The UART offers readable FIFO levels.
All channels generate interrupts on CompactPCI interrupt INTA. For fast interrupt source detection the UART provides a special Global Interrupt Source Register.
All serial channels use ESD protected transceivers up to ±15KV.
The TCP466 can operate with 3.3V and 5.0V PCI I/O signaling voltage.
Software Support (TDRV002-SW-xx) for different operating systems is available.
Features
- Standard 3U 32-bit CompactPCI module conforming to PICMG 2.0 R3.0
- 4 channels with programmable RS232 / RS422 / RS485 interfaces
- High performance asynchronous serial interface (up to 5.5296 Mbps)
- Hardware handshake support available
- Half-duplex mode available
- 64 byte FIFO
- Front panel I/O (HD50 SCSI-2 type connector)
- Optional P14 I/O or P16 I/O
Ordering Options
Manuf. Part No. | | Product Description |
TCP466-10R | | 4 Channel Programmable RS232/RS422/RS485, HD50: 4 channels of high performance programmable RS232/RS422/RS485 asynchronous serial interface; Programmable termination and full/half duplex mode; Programmable baud rates up to 921.6 Kbaud for RS232 and up to 5.5296 Mbaud for RS422/485; Support of RxD, TxD, RTS, CTS, GND per RS232 channel, RxD+/-, TxD+/-, GND per RS422/RS485 FD channel and Dx+/-, GND per RS485 HD channel; 64 byte receive FIFO and 64 byte transmit FIFO per channel, programmable trigger levels for FIFO's; ESD protected line driver/receiver up to 15KV; HD50 SCSI-2 type connector mounted in front panel; PCI I/O signaling voltage 3.3V and 5V; Operating temperature -40°C to +85°C |
TCP466-20R | | 8 Channel Programmable RS232/RS422/RS485, HD50 and J2 I/O: Same as TCP466-10R but additional J2 I/O |
Software and Documentation
Manuf. Part No. | | Product Description |
TCP466-DOC | | User Manual for TCP466 |
TDRV002-SW-25 | | Integrity Software Support: Device driver; Source code; Programmer documentation |
TDRV002-SW-42 | | VxWorks Software Support: Legacy and VxBus-enabled Software Support; VxWorks Device driver; Source code; Programmer documentation |
TDRV002-SW-65 | | Windows Software Support: Device driver; Programmer documentation |
TDRV002-SW-82 | | Linux Software Support: Device driver; Source code; Programmer documentation |
TDRV002-SW-95 | | QNX Software Support: Device driver; Source code; Programmer documentation |
For other operating systems please contact systerra.
Accessories
Manuf. Part No. | | Product Description |
TA101 | | HD50 Cable: 1.8 m cable with two 50 pin male SCSI-2 type connectors.The permissible maximum voltage for the TA101 is 30V DC. |
TA201 | | HD50 Terminal Block: 50 pin terminal block with 50 pin female SCSI-2 type connector. The permissible maximum voltage for the TA201 is 30V DC. |
TA301 | | Cable Kit for Modules with HD50 Connector: 1.8 m cable with two 50 pin male SCSI-2 type connectors; 50 pin terminal block with 50 pin female SCSI-2 type connector.The permissible maximum voltage for the TA301 is 30V DC. |
TCP001-FP | | Front panel extension for 3U cPCI boards: Front panel extension for all TEWS 3U CompactPCI boards to a 6U front panel |
|