PCI-104-BRG Single Board Computer & Controller based on the 1.0 GHz Intel® Celeron® M including PCI to ISA Bridge Module.
The CMX158886XX1000HR-BRG is also available in a rugged, fanless
IDAN enclosure.
Features
- PC/104 Form Factor
- Dual-board solutions with PC/104-Plus Stackable Bus Structure
- Complete PC-compatible Single Board Computer
- Intel Celeron M 1.0 GHz Processor on 90nm
- Thermal throttling
- Nonvolatile storage of CMOS settings without battery
- Stackable 104-pin PC/104 AT bus (via PCI-104 to ISA Bridge Board)
- Stackable 120-pin PCI bus
• 4 Bus master add-on cards capable
- 512 Mbytes BGA DDR SDRAM
• Up to 333 MHz Data Rate
- 32 pin SSD socket supports:
• Miniature 4GB ATA/IDE Flash Disk installed (up to 8 GB)
• Natively supported by all major operating systems
- BIOS Selectable multiPort with Parallel, Floppy Drive Interface (requires XK-CM49 MultiPort Floppy Drive and Cable Kit) and 18-bit Digital I/O with Advanced Digital
Interrupt Modes
- Additional 18-bit BIOS Selectable Digital I/O
- 10/100 Ethernet with PXE Network Boot
- Four RS-232/422/485 Ports
- Two USB 2.0 (Universal Serial Bus) Ports
- EIDE Controller with UltraDMA 100
- 855GME SVGA controller Onboard with 3D Acceleration
- DirectX & OpenGL 3D Accelerator
- Advanced power management features
- Advanced Thermal Management
• Thermal Throttling reduces clock speed to prevent thermal runaway
• Auto Fan Control only runs fan when needed
• SMBus Temperature Monitor for CPU and board temperature
• Mini Fan Heatsink with Auto Fan control
• Passive Structural Heatsink & Heatpipes in IDAN and HiDAN System Configurations
- Advanced Programmable Interrupt Controller (APIC)
- 24 interrupt channels with APIC enabled (15 in legacy PIC mode)
- 3 timer/counter channels
- High resolution 100 MHz APIC timer
- RTD Enhanced AMI BIOS with ACPI, USB Boot and Quick Boot modes
- Advanced Configuration and Power Interface (ACPI)
• ACPI 1.0 Compliant
• Supported power down modes: S1 (Power On Suspend), S3 (Suspend to RAM), S4 (Hibernate), and S5 (Soft-Off)
• CPU Clock Throttling and Clock Stop for C0 to C3 Support
• Also supports APM 1.2 for legacy power management
- 3.3 V or 5 V PCI bus signaling
- 400 MHz, source-Synchronous Front Side Bus
- Supports MMX and SSE2 instructions
- Math coprocessor
- Internal Cache
• L1 - 32 KB of instruction and 32 KB data; L2 - 2 MB
- Y2K compliant real time clock (external battery required)
- Watchdog timer
- PS/2 Mouse Port
- Keyboard Port
- Speaker Port
Ordering Options
| Manuf. Part No | | Part Description |
| CMX158886CX1000HR-BRG-512 | | PC/104-Plus cpuModule with 512MB SDRAM |
Accessories
| Manuf. Part No | | Part Description |
| XK-CM88 | | Cable Kit |
| XK-CM49 | | Floppy Drive and Cable Kit |
| BRG1825 | | PCI to PCI Express Bridge |
|
